Model #: 8680211761406 Unit of Measure: BG Quantity Per Unit: 500 Minimum order: 1 Order Increments: 1
Inside diameter: 3/8"
Flange diameter: 0.75"
Neck length: 0.31"
#2 Long Neck solid brass 9mm ClipsShop metal grommets and washers with Antique Brass finish 3/8" ID hole size, 500 pieces of each.
Apply 3/8" ID ClipsShop #2 long neck grommet with the following ClipsShop manual & Pneumatic machines:
| CSTIDY-51 |
CSTEP-2 |
CSTON-1 |
CSBUR-1 |
CS-PIC-2 |
| CSTIDY-41 |
CSTEP-2 L |
CSTEP-1 |
CS-BGTEP |
CS-PIC-3 |
Note: Our ClipsShop brand grommets fit our ClipsShop brand self-piercing stainless steel dies. They have also been known to fit on certain Micron and Stimpson dies. Micron calls 3/8" ID grommets a #2. If you have an existing Micron #2 die then you should order our #2 grommets to fit it. If you plan on using our grommets with a different brand of machine, we suggest you order sample grommets for testing before you buygrommets in full bags. Open bags of grommets may not be returned. If you have a Hiker hand press, check out our special die conversion adapter so you can apply our ClipsShop grommets with your Hiker hand press.
Note: ClipsShop #2 long neck grommets have the same 3/8" - 0.375" hole size as a #2 grommet but they have a longer neck length for thicker material such as corrugated plastic, coroplast, foam board, gatorboard, and foam core. See the grommet chart for more size information and to buy grommets.
While the #2 long neck 3/8" hole size grommets are self-piercing, it is strongly recommended that you pre-punch a hole. Without a pre-punched hole, you may crush your material if you are not careful. The grommets will pierce most materials but with a pre-punched hole, you can avoid any crushing.
Alternate Part Numbers associated with this product: #2LN GWAB and CSGAB-2LN.
|
